You can use a toothbrush as an alternative to a nylon brush. There are also grip tape erasers that can help you maintain your board between deep cleanings.
If your board becomes saturated, dry it off immediately as a waterlogged board can lead to warping and cracking. [3] X Research source
Avoid getting the metal parts on the underside of your board wet.
Paper towels or napkins rubbed against your grip tape will create a mess.
If your wheels make a lot of noise or don’t spin well, there’s a good chance they need to be cleaned.
You may damage the shield slightly while doing this, so be careful.
You can also use a citrus based cleaner with an orange oil or lemon juice to clean your bearings.
Be careful when handling the hot bearings because they can burn you.
Oil will make your wheels turn faster but also makes your bearings less resistant to dirt and debris. Synthetic grease will increase the longevity of your bearings and requires less maintenance, but will make your wheels spin slower than if you used oil.
You should conduct regular maintenance on your bearings, especially if they are noisy or they are not spinning properly.
If you are having problems lifting the wax from your board, you can drip some liquid coconut oil onto the surface of your board to try to loosen it.
You can also use inflatable boat cleaner.
Use citrus cleaner as an all-natural alternative to WD-40.
Remember to re-wax your longboard before you take it out to the ocean again.
